Nov 09, 2026 Leave a message

Titanium Thread Galling: Causes and Assembly Precautions

Why Do Threads on Titanium Parts Seize?

A shaft, connecting rod, or fastener machined from titanium bar may turn freely for the first few threads during assembly. Then resistance rises sharply, until the part will neither tighten nor back out.

There is no rust, and the thread dimensions show no obvious problem. So why has the connection seized? Alongside cross-threading, burrs, and fit problems, another possible cause is galling-a form of surface damage that deserves particular attention with titanium.

What Happens Between the Thread Surfaces?

Thread surfaces that look smooth still have microscopic high points. During tightening, the mating threads slide against each other under pressure. Local adhesion can develop, pulling material from one surface and depositing it on the other. These deposits increase interference and promote further damage, allowing galling to spread quickly.

In severe cases, the threads seize. Applying more force can strip the threads or even break the part. Titanium and its alloys are among the materials susceptible to this problem: corrosion resistance does not prevent adhesive wear at sliding thread contacts. Nord-Lock's technical explanation of thread galling describes this process.

Simply switching to a higher-strength titanium alloy therefore offers no guarantee against galling. Load-carrying capacity and the friction and adhesion between contacting surfaces need separate assessment.

A Thread That Will Not Turn May Not Be Properly Clamped

For a threaded joint that requires preload, the aim of assembly is to achieve the specified clamping force. Tightening torque is one means of controlling that process.

When thread friction increases abnormally, more of the applied torque is consumed in overcoming friction. The tool may reach its torque setting before the joint develops the required preload. A sudden increase in turning resistance should therefore not be taken as proof that tightening is nearly complete.

Adding lubricant also means the original dry-assembly torque cannot simply be reused. With other conditions unchanged, lower friction can produce a higher preload at the same torque. Assembly instructions should specify lubrication conditions together with torque requirements. If the lubricant, coating, or mating component changes, the suitability of those requirements needs to be reviewed. Nord-Lock's guidance on lubrication and preload likewise stresses following the manufacturer's lubrication instructions and adjusting torque where necessary.

What Should Be Checked Between Machining and Assembly?

Start with the threads themselves. Check the entry chamfer, burrs, trapped chips, damaged thread profiles, and alignment during engagement. If a part is difficult to engage from the outset, do not force it into place with a larger tool. For connections with a self-locking feature, distinguish the intended prevailing torque from abnormal binding and follow the applicable assembly procedure.

Measures to reduce galling should suit the actual operating conditions. Options to assess include suitable lubrication or surface treatment, a validated combination of mating materials, and a lower assembly speed. Appropriate lubrication and reduced installation speed are also recommended in the thread-galling guidance cited above.

"Apply some anti-seize" is not a complete specification. Operating temperature, contact with process fluids, and cleanliness requirements can restrict which products are suitable. If a coating is used, its effect on thread fit also needs to be considered. The name of a grease or coating alone does not establish its suitability for every titanium connection.

For threaded components machined from titanium bar or forgings, raw-material acceptance should be linked with assembly validation. A material certificate can document chemical composition, mechanical properties, and other agreed requirements. On its own, it cannot demonstrate how the finished threads will behave during assembly.

Small-batch validation should use mating components, surface conditions, lubrication, and assembly methods representative of the parts to be supplied. If abnormal resistance or visible surface tearing appears, stop and investigate rather than continue applying force. Connections intended for repeated assembly and disassembly should also be checked for thread damage after removal.

Stating the intended threaded application, expected disassembly requirements, and any planned surface treatment at the purchasing stage helps the material supplier, machinist, and assembly team agree on requirements before finished parts reach assembly.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry