Titanium in Chlorine Service: Why Wet and Dry Conditions Matter
Titanium is used in certain types of chlor-alkali equipment. That can make "titanium resists chlorine" sound like a general rule: if the process contains chlorine, titanium is a suitable choice.
That conclusion leaves out a critical condition-moisture.
Even with chlorine gas, a change in water content can fundamentally change titanium's suitability. Experience with wet chlorine service cannot simply be transferred to a dry chlorine system.
Moisture Changes the Conditions That Protect the Surface
Titanium's corrosion resistance depends on a protective surface oxide film. Under suitable wet chlorine conditions, the environment helps maintain titanium in a passive state, allowing good corrosion resistance.
Dry chlorine presents a different situation. TIMET's corrosion resistance handbook explains that dry chlorine can attack titanium rapidly and may cause ignition when the moisture content is sufficiently low.
The difference goes well beyond a modest increase in corrosion rate. The AIChE Center for Chemical Process Safety's chlor-alkali materials guidance also identifies titanium combustion in dry chlorine service.
Wet and dry chlorine must therefore be treated as distinct material-selection conditions. Titanium's established use in certain wet chlorine equipment does not demonstrate suitability for dry chlorine exposure.
"Wet" also needs a more precise meaning than the detection of some water in the gas. The question is whether sufficient moisture is available at the titanium surface to maintain protection under the actual temperature, pressure, and flow conditions. TIMET notes that gas pressure, flow, temperature, and mechanical damage to the oxide film influence the moisture required.
A water-content value taken from a reference without its associated test conditions is therefore an incomplete engineering basis.
What Does "Chlorine-Containing Service" Need to Specify?
Start by identifying the medium itself.
Chlorine gas and chloride ions in brine are different chemical species. Chlorine-containing aqueous solutions should not be grouped with dry chlorine gas either. Describing an application only as a "chlorine-containing environment" leaves its composition, phase, and moisture conditions undefined.
For titanium plate, bar, or forgings intended for chemical equipment components, the enquiry should help the material supplier and equipment designer understand the actual medium, normal temperature and pressure ranges, and how water content is defined and may vary.
"Wet chlorine during normal operation" is only part of that assessment.
Startup, shutdown, process changeovers, and abnormal conditions may differ from steady production. Material selection needs to consider whether any of these stages could expose titanium to unsuitable dry chlorine conditions, rather than relying on a single set of normal operating data.
Different sections of the same chlor-alkali plant may also require different materials. The component's location and the specific process stream it contacts provide more useful information than the broad description "for the chlor-alkali industry."
Technical documents should state the units used for water content, the phase to which the measurement applies, and the conditions under which the requirement holds. A statement that moisture is "within specification" is difficult to connect with material suitability unless its measurement basis and applicable range are clear.
These conditions should be assessed by the process designer together with materials and corrosion specialists to establish a selection basis for the specific equipment. The supplied grade and quality must still meet the order requirements, but a compliant material certificate alone does not establish compatibility with the process medium.
Titanium's corrosion resistance has defined environmental limits. In chlorine service, identifying wet and dry conditions-and how those conditions can change during operation-is essential to deciding whether a titanium component is suitable.




